Clik here to view.
1/100 Graze part 2
Continuing on with Graze, I put Alcald grey primer on all the armour pieces while I continued to work on the frame.The plastic on the armour pieces was a bit "sharper" when I snipped it out than the...
View ArticleClik here to view.
1/100 Graze part 3
Continuing on with the Graze, I used the burnt sienna oil paint on the axe and gun.I used the Uschi powder on the blade edge of the axe, and although it looks good it's way too clean so I'll add more...
View ArticleClik here to view.
1/100 Graze part 4
To rust up the armour, I started by applying some Vallejo natural steel acrylic paint with the end of one of the skewers I use to hold pieces while painting. By carefully dotting on the chipping you...
View ArticleClik here to view.
1/100 MG Gouf
Ok, time to blog again! Following on from the chipping medium experiments, I'm going to try them on an MG Gouf. For the frame, I'm not doing anything different than usual. I've used Tamiya gunmetal as...
View ArticleClik here to view.
1/100 MG Gouf part 2
Now onwards to see how the chipping medium is going to work!I want to "chip" in-situ to guide the placement along visible or proud edges, and also to bias the outer sides of pieces or where the armour...
View ArticleClik here to view.
1/100 MG Gouf
The MG Gouf has been a fun build. The Vallejo chipping Medium has been reasonably successful, and it's made for a much quicker weathering recipe than doing it all with oil paints. Once I was happy with...
View ArticleClik here to view.
1/100 Hu-Nu Gundam 2
I took this photos a while back in progress on Hi-Nu. I really like the Createx pearl blue colour. It's not the strongest of paints, so all pieces got healthy coats of Future Finish to protect...
View ArticleClik here to view.
1/100 UC Kshatriya 2
Time to look at paint for Kshatriya. I wanted to go with a more subdued green (for the most part) and to use Tamiya paints (thinned with lacquer thinner) as they're stronger than the Createx pearl...
View ArticleClik here to view.
1/100 UC Kshatriya 3
Progress is slow on Kshatriya.I modified the skirt section parts with very small pieces of plastic to close the hole where the ball of the peg sits. This will make the ball joint actually work rather...
View ArticleClik here to view.
1/100 UC Kshatriya 4
So after a bit of a break, (check out www.thepolymusicon.com for what I've been working on) I'm back trying to complete this resin kit of Kshatriya. I looked at the sleeve pieces I'd painted and found...
View Article
